cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1299
Views
0
Helpful
0
Replies

ASR 1002 Monitor Session doesn't works.

rcollado_
Level 1
Level 1

Hello,

I am trying to configure a monitor session in a Cisco ASR1002 but it doesn't works (sniffer is on interface gigabitEthernet 0/0/3).

My config is:

monitor session 10 type local
source interface GigabitEthernet0/0/0
destination interface GigabitEthernet0/0/3

and interfaces are up:

#show interfaces GigabitEthernet0/0/0

GigabitEthernet0/0/0 is up, line protocol is up

....

  5 minute input rate 241240000 bits/sec, 26651 packets/sec
  5 minute output rate 4000 bits/sec, 6 packets/sec

...

#sh interfaces gigabitEthernet 0/0/3
GigabitEthernet0/0/3 is up, line protocol is up (monitoring)

.....

5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec

......

Is very urgent for me so any help would be very appreciated.

Thanks in advance for your help.

Regards.

Ruben.

0 Replies 0