cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1081
Views
0
Helpful
1
Replies

Bandwidth utilization on topology diagram of LMS 4.2

Pandian G K
Beginner
Beginner

Hi,

  I am running LMS 4.2 , using that i am monitering some switches . I am using topology services also  . In that i am getting veiw of all connected devices with links. But bandwidth utilization is for those links are not showning in topology veiw .

Is there any settings to be done in LMS 4.2.2 or any configuration changes to done on my switches ??  to find the traffic flow  bandwidth utiliztion.

thanks ,

pandian .

1 Reply 1

rgomes
Beginner
Beginner

Hi

You have to enable RMON to measure bandwidth utilization.

Take a look on the Monitoring and Troubleshooting With Cisco Prime LAN Management Solution 4.2 guide.

Begining on the page 7-43 you can find the procedure.

Hope you can set it

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: