Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I am having a active- secondary ASA which is connected to a two downlink switches..Please suggest how redundancy can be achived..Thanks ,gkp..
Hi, I am running LMS 4.2 , using that i am monitering some switches . I am using topology services also . In that i am getting veiw of all connected devices with links. But bandwidth utilization is for those links are not showning in topology veiw ...
Hi , I have discovered my switches in LMS but it is showing unreachable what can be the reason ?Looking forward for your comments .thanks in advance,Pandian G K
Hi all, I am installing LMS 4.2 on Windows 2008 R2 standard edition 64 bit. During installation its showing the following error.And I am not able to proceed the installation. Please suggest what can be done ????PFA image showing error.Note : My Win...
After Some googleing i found that it is not supported..for details refer below link http://www.cisco.com/en/US/docs/security/security_management/cs-mars/6.1/compatibility/local_controller/dtlc6x.html#wp85319HTH,GKP
Dear Marius,Please correct me if I am wrong. Configuring port channel will be fine if we are using a single switch.Since it is a two different switches connecting to a ASA port channel will not come up ..Thanks,GKP
Hi Marius,Thanks for your response. I have configured the ASA in Active/ Standby mode. But I need configuration on the ASA for the Down switches connectivity.Since two interfaces from the firewall will connect to two different switches. Is it possibl...
