Catalyst 2960G; set user and password for web interface
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2017 05:38 AM - edited 03-01-2019 06:10 PM
Hi to all,
cause i have not found anything by myself, I hope you can help me.
I am working on a catalyst 2960G and tried to set an user for the web interface, cause I do not know the old credentials.
Till now I was not able to set it and did not find any clue how to do that.
Telnet and console password were no problem, but in this case I am loosing my mind.
Thank you very much in advance!
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2017 08:46 AM
Hello Tim,
Usually Cisco device has the same user/pass for CLI and HTTP.
Try to run the command "ip http authentication local" and try to access using CLI user/pass.
