Hi,
with our new Catalyst 9000 switches we want to use snmpv3 to send traps.
Thats what I configured:
snmp-server engineID local 1234567890ABCEDF
snmp-server group SG_SERVERFARM v3 priv
snmp-server trap-source Vlan%NUMBER%
snmp-server enable traps
snmp-server user SNMP_USER SG_SERVERFARM v3 auth md5 %PASSWORD1% priv aes 256 %PASSWORD2%
snmp-server host %IP-TRAP RECEIVER% vrf %VRF-NAME% version 3 priv SNMP_USER
To check if the problem is on the switch I debug ip packets with the following access-list
access-list 2000 permit ip host %IP-TRAP RECEIVER% any
access-list 2000 permit ip any host %IP-TRAP RECEIVER%
debug ip packet 2000
I see no packet if I trigger an event that should send a trap.
Any idea what is missing or what I did wrong?
Kind regards
Christoph