Hello everyone,
I am trying to install Cisco Configuration Professional 2.4 Express on my 2821 router. During the installation process, I get notified there is 0 bytes available of routers flash memory. When I run a "show flash:" command, I receive the following error:
%Error show flash: (No device available)
The output of the "show version" (edited) command is:
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4, RELEASE SOFTWARE (fc1)
ROM: System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1
Router uptime is 2 weeks, 5 days, 4 hours, 54 minutes
System returned to ROM by power-on
System image file is "flash:c2800nm-adventerprisek9-mz.124-12c.bin"
Cisco 2821 (revision 53.51) with 512000K/12288K bytes of memory.
Processor board ID FTX1006C4SB
2 Gigabit Ethernet interfaces
1 Serial interface
2 Virtual Private Network (VPN) Modules
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
500976K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
After some reading on Cisco site, I saw that 2800 routers do not support internal flash, but only CF cards. What I would like to know is how can I install CCP Express on CF card?
Thank you in advance.
