Cisco 2900 Switch Faulty?? Any factory default reset button/procedures?

[huytuan]

Hi, I've got a Cisco 2900 Switch. Someone just accidently put an ethernet cable from his NIC on the computer to the Console port of this switch. Now I try to access the Console Port of this switch with RS232+Rollover cable, it seems not to work.

The settings I used in Hyperterminal are:

9600bps, 8 data bits, no parity, 1 stop bits, none flow control.

But I cannot access the Switch. Is there any factory default reset button to press to reset everything. Or is the switch a piece of garbage now?? Thanks in advance.

[stschmidt]

Try it with this:

*Bits per second (baud): 9600

*Data bits: 8

*Parity: None

*Stop bits: 1

*Flow Control: Xon/Xoff

http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml