Cisco 2921 configure router for internet access

[christiaanh2]

Hi everyone I have a Cisco router 2921 with iOS 15 I want to configure this router for internet access at g0/0 you have to use the command int g0/0 dhcp I used that command and then my moden automatically gives an ip address but for the other Interface I don't know what ip address to add I have now connected my computer directly to the modem and then I get this information when I enter ipconfig at CMD Connection-specific DNS Suffix . : home
IPv6 Address 2a02:1810:a412:be00:9922:de3d:936:1ab8
Temporary IPv6 Address 2a02:1810:a412:be00:18b7:fef5:3374:d786
Link-local IPv6 Address fe80::9922:de3d:936:1ab8%16
IPv4 Address 192.168.0.189
Subnet Mask 255.255.255.0
Default Gateway fe80::6802:b8ff:fe86:246%16
192.168.0.1 

does anyone know what ip address i should add to interface g0/2

[Georg Pauwen]

Is it working ? Do you have Internet access from a PC connected to the switch ?

[christiaanh2]

855 490 652

c2wddchf

[Georg Pauwen]

Password is invalid

[christiaanh2]

855 490 652

6qjd6

[christiaanh2]

855 490 652

c2wddchf 

I had to restart my Teamviewer That's why I'm sending you the login details again, they are correct

[christiaanh2]

Thanks for the help I finally have internet through the router 

[Georg Pauwen]

Good stuff !

[christiaanh2]

you can now log in via Teamviewer

[Georg Pauwen]

Says you are not connected. Are there still problems with the router ?

[christiaanh2]

No not at all I have a good internet connection every device in my house also the mobile phones have been given a new IP address

[christiaanh2]

I have another question Can you also set up a Cisco ASA 5510 firewall for my network security?

[Georg Pauwen]

Hello,

sure thing. Where is the ASA going to be located (e.g. between the 2921 and the ISP router, or in front of the ISP router) ?

[christiaanh2]

This one comes behind the Cisco 2921 router

[christiaanh2]

Hi again Thank you for helping me configure my router I now have the following problem I have an APC UPS backup Supply connected to my server Rack which powers the router when I rebooted the router all my configuration was gone I know you saved the configuration but it's gone I have to start from scratch please if you have the time reconfigure the router with ipv4 and ipv6 please help me

[Georg Pauwen]

Hello,

if you can provide the Teamviewer login, I can reconfigure your router.