cisco 2960-x express setup does not submit ip settings

[BG147]

After applying new ip settings in express setup, I press submit but the changes do not apply.

A new page opens to the new ip but after setting nic to the same subnet I cannot connect.

I change back to dhcp and connect to the default 10.0.0.1 again.

i have tried multiple browsers and computers.

[marce1000 · Accepted solution]

 - Is there an error when you press Submit ? You may be able to initially configure through the console, check this thread :

         https://community.spiceworks.com/topic/1243946-cisco-2960g-24tc-l-no-express-setup-after-resetting

 M.

[BG147]

Hello, No no error...

[marce1000]

 - Ok , as stated check out the  thread.

[BG147]

Thank you! ive been at it for a few hours! This worked

[BG147]

Do you know how to reset the switch from CLI? Pressing the mode button does not do a factory reset as manual states. I cannot log into one switch because the default password doesn’t work.