Hi guys,
I just put my hands on a 2511-RJ unit. Here is the setup:
show run
Current configuration : 1308 bytes
!
! Last configuration change at 13:20:28 EEST Mon Sep 24 2012 by florinb
! NVRAM config last updated at 11:19:07 EEST Mon Sep 24 2012 by florinb
!
version 12.2
service timestamps debug datetime msec
service timestamps log datetime localtime
no service password-encryption
!
hostname 2511-RJ
!
logging buffered 8192 informational
aaa new-model
!
!
aaa authentication login default local
aaa authorization exec default local
aaa session-id common
enable secret 5 $1$g4Pi$PLnBkf8ZWr7atFNAnkHyA.
!
username florinb privilege 15 secret 5 $1$PIv/$xLtxN8JKMkJkQ1yK8YsKb.
clock timezone EEST 2
clock summer-time EEST recurring last Sun Mar 4:00 last Sun Oct 3:00
ip subnet-zero
ip domain name laf.ro
ip host aa 2010 1.1.1.1
!
!
!
!
!
interface Loopback10
ip address 1.1.1.1 255.255.255.0
!
interface Ethernet0
ip address 172.20.20.18 255.255.255.0
!
interface Serial0
no ip address
shutdown
!
ip classless
ip route 0.0.0.0 0.0.0.0 172.20.20.1
no ip http server
!
!
no cdp run
!
alias exec log show logging
alias exec sir show ip route
alias exec sib show ip int brief
alias exec sid show interface description
!
line con 0
line 1 16
exec-timeout 0 0
no flush-at-activation
no exec
transport input telnet
line aux 0
line vty 0 4
exec-timeout 60 0
!
ntp clock-period 17179940
ntp server 93.190.144.26
end
I use putty to connect to 1.1.1.1 on port 22. Then here is the sequence:
2511-RJ#aa
Trying aa (1.1.1.1, 2010)...
% Connection refused by remote host
2511-RJ#clear line 10
[confirm]
[OK]
2511-RJ#
2511-RJ#aa
Trying aa (1.1.1.1, 2010)... Open
User Access Verification
Username: florinb
Password:
Cisco-1812-II>en
Cisco-1812-II#
My trouble is that I CAN NOT disconnect from this session. I tried CTRL+SHIFT+6, X but no luck.
I have to duplicate the SSH session to the 2511 router then use "clear line 10"
I also tried this command:
2511-RJ#terminal escape-character 3
"^C" is the escape character
that replaces the BREAK sequence to CTRL+C
Then I tested it with ping:
2511-RJ#ping
Protocol [ip]:
Target IP address: 4.2.2.2
Repeat count [5]: 100
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to 4.2.2.2, timeout is 2 seconds:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 100 percent (53/53), round-trip min/avg/max = 36/39/40 ms
So CTRL+C stops ping command.
Then I again connect to the "aa" and tried CTRL+C, X ; still CAN NOT disconnect.
Any suggestions?
