Network Management

I have been installing Light Weight AP's and these make LMS device discovery take much longer because they are found via CDP but do not run SNMP. So you suffer the SNMP retry and wait time for each one which adds up with several hundred AP's. I added...

Hello there,Does any one know the SNMP OID for current utilization of ports on Cisco 2960, 3560, and 3750 switches?After enabling mls qos on the LAN, we are experiencing a lot of packet drops on ports of 2960, 3560, and 3750 switches. In an troublesh...

Hi all,trying to access LMS 4.1 WebUI via IP-Address (https://x.x.x.x) with IE8 results in Login-Screen asking for a Domain-Name.As LMS 4.1 for security-reasons isn't configured in DNS this is only way to access WEB-Interface.Using Firefox Domain-Tab...

Hello community, I would like to ask some questions about CiscoWorks LMS 4.0.1.We are using for a few days, and I can't set some request in the system. I hope someone could help me to customize the CW as I would like to use it.- We have some Catalyst...

Hi,Presently we have  purchased Cisco LMS3.2 package now.We need to install the same in our UCS server.My quiry is can we have option to upgrade to LMS 4.1 version with free upgradation.If so let me know how to do the same by upgrading with same LMS ...

hi,   i have a question regarding cisco 500 series switches and it is that if we want to shut down this switch remotely then is it possible or it has to be done manually by going to the switch location and disconnecting the power supply because i don...

Hi Every one I want to install Cisco Access Registrar 5  on two different servers in active/ active designWhat design or requirements for active/ active deploiement ?Using Sun Solaris ? (i know using sun Sloaris i can have this mode of high availabil...

Hi all,I am facing a problem with my LMS 3.2 server. Suddenly I found there is no device reflecing in common services-> device management as well as RME also. I restarted LMS services, server multiple time, reseted casuser, demoted the server from AC...

Hi,I can't choose any devices when I try to launch a NetConfig Job in LMS 3.2. I have to check in the job summary if the device on which I'll apply the job is the good one.Unfortunately, this problem doesn't appear every time so I don't know where to...

Hello,We're using LMS3.2 and have a requirement to email a list of all hosts to our customer each day.Campus Manager can obviously create the report, however, I can't find a way to attach the report to an email to the customer.Ideally I'd prefer not ...