cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1336
Views
0
Helpful
0
Replies

Cisco ap802 access point QOS question

Luca Pecchiari
Level 1
Level 1

Hello,

I am implementing the QOS on a access point ap802 on a cisco 887va.

I have handled the priority of Microsft Teams in this way, and it is working

 

class-map match-any video
 match access-group 116
class-map match-any voice
 match access-group 115

policy-map Wi-Fi
 class video
  set cos 5
 class voice
  set cos 6

interface Dot11Radio0.1
 service-policy input Wi-Fi
interface Dot11Radio1.1
 service-policy input Wi-Fi

access-list 115 remark *************************************
access-list 115 remark # TEAMS AUDIO
access-list 115 permit tcp any range 50000 50019 any
access-list 115 permit udp any range 50000 50019 any
access-list 115 remark ***********************************
access-list 116 remark *************************************
access-list 116 remark # TEAMS VIDEO
access-list 116 permit tcp any range 50020 50039 any
access-list 116 permit udp any range 50020 50039 any
access-list 116 remark ***********************************
access-list 117 remark *************************************
access-list 117 remark # TEAMS SCREEN SHARING
access-list 117 permit tcp any range 50040 50059 any
access-list 117 permit udp any range 50040 50059 any
access-list 117 remark ***********************************

This is working, before apply this audio was orrible.

 

i have tryed to match IP precedence and DSCP but all was going in the class-default, so no matching at all. I applyed service-policy in inbound on the radio interfaces.

 

My question: there are anoter ways to do this? Is this the best way to QOS voice incoming to Wi-Fi and going to Internet?

 

Thank You.

 

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: