cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2579
Views
0
Helpful
0
Replies

Cisco IOS NTP: "show ntp associations" versus "show ntp status"

kerstin-534
Level 1
Level 1

what is the difference of the commands "show ntp ass det" and "show ntp status" ?

these commands differs on the referenced time source.

switch#sh ntp ass detail

Load for five secs: 17%/4%; one minute: 20%; five minutes: 20%

Time source is NTP, 10:45:15.469 MET Tue Feb 4 2014

10.1.5.4 configured, ipv4, sane, valid, stratum 2

ref ID 154.71.99.39   , time D69B3383.9D414772 (10:38:11.614 MET Tue Feb 4 2014)

our mode client, peer mode server, our poll intvl 1024, peer poll intvl 1024

root delay 0.38 msec, root disp 5.93, reach 377, sync dist 11.77

delay 0.84 msec, offset 0.3778 msec, dispersion 1.06, jitter 0.97 msec

precision 2**21, version 4

assoc id 26601, assoc name 10.1.5.4

assoc in packets 12339, assoc out packets 12361, assoc error packets 28

org time 00000000.00000000 (01:00:00.000 MET Mon Jan 1 1900)

rec time D69B347C.4ACDE42A (10:42:20.292 MET Tue Feb 4 2014)

xmt time D69B347C.4ACDE42A (10:42:20.292 MET Tue Feb 4 2014)

filtdelay =     0.88    0.87    0.85    0.90    0.84    0.90    0.89    0.87

filtoffset =    0.31    0.31    0.32    0.28    0.37    0.32    0.25    0.31

filterror =     0.97    1.00    1.03    1.06    1.09    1.12    1.15    1.18

minpoll = 6, maxpoll = 10

FD8C:2208:32F7:8EA::5 configured, ipv6, our_master, sane, valid, stratum 1

ref ID .PPS., time D69B318B.92FDD88A (10:29:47.574 MET Tue Feb 4 2014)

our mode client, peer mode server, our poll intvl 1024, peer poll intvl 1024

root delay 0.00 msec, root disp 0.42, reach 377, sync dist 17.18

c4507r01#show ntp status

Load for five secs: 19%/4%; one minute: 20%; five minutes: 20%

Time source is NTP, 10:42:03.441 MET Tue Feb 4 2014

Clock is synchronized, stratum 2, reference is 81.201.114.7

nominal freq is 250.0000 Hz, actual freq is 249.9987 Hz, precision is 2**10

ntp uptime is 752342800 (1/100 of seconds), resolution is 4016

reference time is D69B2950.47571873 (09:54:40.278 MET Tue Feb 4 2014)

clock offset is 0.9771 msec, root delay is 0.94 msec

root dispersion is 47.43 msec, peer dispersion is 1.03 msec

loopfilter state is 'CTRL' (Normal Controlled Loop), drift is 0.000005068 s/s

system poll interval is 1024, last update was 2881 sec ago.

switch#sh ntp associations

Load for five secs: 18%/4%; one minute: 20%; five minutes: 20%

Time source is NTP, 10:53:12.750 MET Tue Feb 4 2014

  address         ref clock       st   when   poll reach  delay  offset   disp

+~10.1.5.4      154.71.99.39     2    690   1024   377  0.848   0.377  1.069

*~FD8C:2208:32F7:8EA::5

                  .PPS.            1    400   1024   377  0.931   0.892  1.007

* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured

0 Replies 0