I have a majority of my home network configured to where I would like it, I just need to figure out how to get it to route to the internet! The Cisco Community has been of great help. Once I have the basics configured I can backup my configs and fiddle around with different things and configuration variables. There's still a few things I would like to learn how to configure and learn about.
What is this "Embedded Service Engine" and how can I use it? I can do sub interfaces and bridging with it?
Hurricane Electric ipv6 over ipv4 Tunneling and then configure multiple IPv6 DHCP vlans with ranges and a block variables for Static hosts.
Configure ddns with afraid.org.
Create IPSec VPN Tunnels to Remote Virtual Machines. and assign remote gateways for vlans.
OSPF to ISP? (Some kind of out of norm routing bridge directly to my isp? 802.1Q?)
And a few other things. Will update later.
--------------------- "Fortune favors the brave." ▊▊▊
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...