Cisco network Assistant Catalyst C1000

[jonathanghignoli]

Salutations,
I am migrating my Cisco Catalyst 2950s with the Catalyst 1000s. I have added the new Devices to the CNA Community, but the tool does not recognize them. Do you have a solution on this? Thank you

[Mark Elsen · Accepted solution]

        - CNA is old and will not support these models , you will need at least Cisco Prime.

 M.

[jonathanghignoli · Accepted solution]

Thanks marce1000, in addition to Cisco Prime, what software do you recommend to manage, monitor, configure the catalyst C1000 and C9200 switches? I have about 200 Catalyst C2950 and C2960 Switches and have always managed them with Cisco Network Assistant and Cisco Active Advisor. Do you have some advice? Thank you

[Mark Elsen · Accepted solution]

                             >...and have always managed them with Cisco Network Assistant 

 - As stated you will have no other option then to start using Cisco Prime, if you want to incorporate the latest generation of cisco switches too.

 M.