Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I purchased a Catalyst 1300. I configured the Mgt Vlan and connected the port in trunk. I would like to set the VTP Domain and the VTP Mode Client so as to be able to associate the vlans of my Cisco 9300 (Switch l3) on the interfaces. Can you give me...
Good morning, I have a Catalys 9300. I have a Windows Server 2019 DHCP server. Some PCs on the VLANs correctly acquire the IP from the scopes configured on the Server, some PCs on other VLANs of the 9300 are unable to acquire the IP directly from the...
We changed the Vtp domain on the Cisco 3850 VTP Server. All the Cisco switches 2924, 2950,2960, 1000 connected to it after having set the new VTP domain, in client mode have propagated the new vlans. Once the VTP Domain has been changed (despite the ...
Salutations,I am migrating my Cisco Catalyst 2950s with the Catalyst 1000s. I have added the new Devices to the CNA Community, but the tool does not recognize them. Do you have a solution on this? Thank you
Hello, I would like to configure LDAP authentication to manage the switch. With the Web Gui I can't configure it. With the CLI I tried, I can connect to the server, but I can't authenticate. Do you have any solution?
Thank you for your answer. I looked into it further. Actually the switch does not support vtp. The switch is in transparent mode. Okay. I will configure the vlans on the switch. Thank you
In the Cisco catalyst 1300 switch I did not find VTP commands. I'll paste the "sh?" . While in the catalyst 1000 the vtp commands exist calmly. I need to know how to set the VTP Domain on the Catalyst 1300 switch that I purchased a few days ago. SW-C...
I solved it, the problem is that if an IP is registered on the dhcp coming from vlan81 and subsequently the switch port is changed to vlan72, the dhcp does not recognize the change of vlan and the record on the dhcp remains the same because most like...
I solved the problem!.The Catalyst C500 has gone into vtp client mode.The problem was that the propagated vlans must be at most 36. The Cisco Catalyst C500 does not accept more than 36 vlans. If the VTP Server propagates more than 36 vlans the cisco ...
I deleted the flash:/vlan.dat, restarted the switch, but the vlans remain the same as before. Do you have any advice for me?. I would like to make this vlan update automatism work, instead of entering them by hand. There are about 30 new vlans. Thank...
