cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
791
Views
0
Helpful
0
Replies

Cisco Prime 2.2 Config Deploy failed Nexus 5548 "terminal width"

m.o.andersson_2
Beginner
Beginner

Hi,

strange problem here. Im trying to deploy a config through Cisco Prime Infrastructure 2.2 on a couple of Nexus devices. It all looks good until i try to do this on Nexus 5548 where i get this error:
 
Error occured while executing the command terminal width 0.Command Output : ^ % Invalid number, range is (24:511) at '^'
Well i understand why it failes, you cannot set the width to 0, only values are allowed between 24-511. But it works on the other Nexus devices, for example Nexus 7700 and Nexus 3000 without any errors and they only allow width between 24-511. So first question is of course how can i get this to work, is there any work around?
Second question is why do Cisco Prime want to set the width to 0? It doesnt make sense to me?
 
Cheers! // Mattias
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: