11-27-2013 12:18 PM
I have deployed some CLI templates I have created to configure multiple local accounts on some switches. However the cli templete only appears to accept conf t commands, it will not accept 'write mem' or 'copy run start' at the end to save the altered running config to startup. this results in running and startup being 'out of sync' in the configuration archives, and runs the risk of a power failure causing the config to revert back to startup. Does anyone know how to ensure the altered running config is saved to startup during the config template deployment?
11-28-2013 09:19 AM
I don't know if this has been fixed in 2.0 or not. By the looks of the bug it hasn't. However, there is a workaround-
BugID
Prime Infrastructure - No option to save running config to startup
Conditions:
Prime Infrastructure 1.2/1.3
Workaround:
Create a Configuration Template that runs either:
"do write mem"
Or for devices which no longer support "write mem", use:
"file prompt quiet
do copy run start
no file prompt quiet"
12-04-2013 02:05 AM
Thanks Rob, however for my 6509E with 2T Supervisor will still not accept in config mode or submode:
file prompt quiet
do copy run start
no file prompt quiet
Any other ideas?
12-12-2013 09:12 AM
Hello,
how can I save the config from a Cisco Catalyst 2950?
This device do not support the command "do write mem" or "do copy run start".
Kind regards
12-13-2013 02:19 AM
#MODE_ENABLE
write memory
#MODE_END_ENABLE
or
write memory
so "do" will not be need
Steffen
12-13-2013 02:28 AM
Just use this command:
Switch#wr
Regards
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide