Cisco Prime Infrastructure 1.2 with SNMPv3

[Mustafa Al Housami]

Dears,

I am trying to add a router on Cisco Prime Infrastructure 1.2 using snmpv3 (authpriv, sha & aes256). When i go to device work center and add a device, i cannot find the AES-256 in the privacy options. Only None, DES, and AES-128 are available.

Is there any workarround?

Please advise.

Moustafa

[Marvin Rhoads]

PI only supports SNMP privacy up through AES-128 at this time. Reference the guide section on adding an new SNMP credential entry.

Additionally there is a bug with SNMP v3 support in PI 1.2. It should be resolved in PI 1.3.

[Mustafa Al Housami]

Hi Marvin,

Thank you for the valuable response. Please note that when i go to discovery settings i can see the AES-256. However, when i try to add the device from device work center it does not display AES-256.

It is a weird behavior.