Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,I am trying to add a router on Cisco Prime Infrastructure 1.2 using snmpv3 (authpriv, sha & aes256). When i go to device work center and add a device, i cannot find the AES-256 in the privacy options. Only None, DES, and AES-128 are available.I...
Dears,Is there any way to configure ASA as an EZVPN Server, authenticate and authorize the clients using tacacs on the ACS by downloading ACLs per user?Please advise.
Dears,I have UCCX 7.0 and I am facing the following problem:I configured an outbound campaign and the agents which are in ready state are not prompted to accpet any call. The % of logged agents is 100%. Direct Preview is enabled in CDA.I also tried ...
Dear sir,I have a DMVPN topology and I am trying to access a web server through the DMVPN but i cannot. However the server port 80 is open.I tried to access the web server locally and it is successull.I tried to install a router with only NAT configu...
Hi Marvin,Thank you for the valuable response. Please note that when i go to discovery settings i can see the AES-256. However, when i try to add the device from device work center it does not display AES-256.It is a weird behavior.
