cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
470
Views
0
Helpful
3
Replies

Cisco Prime Infrastructure 3.10 Splunk API Cisco PI Add-on Issue

buhawi
Beginner
Beginner

Anyone using Cisco PI Splunk Add-on that is having issue with Cisco PI 3.10? Any help/suggestions.

3 Replies 3

BrianC001
Beginner
Beginner

Hi 

We are using it PI 3.10.3 withno issue. Could you please specify the issue?  Is it working on 3.9? Something happened after upgrade? Is it a fresh install?

buhawi
Beginner
Beginner

It was working in 3.7, upgraded to 3.10.3, it is a new VM and did a back up and restore to upgrade. Using same Splunk cisco PI add-on version 2.1.2. There is no output when querying in Splunk. Hostname was changed in PI with this upgrade but IP address is the same, the new PI hostname was changed in Splunk. 

BrianC001
Beginner
Beginner

If so, I'm guessing you should put the credentials again. I recommended to reset the nbi read only account in the PI, and re-enter it into the splunk add on account too. Also, please try reboot the Splunk. Sorry for not helping much, but we had similar issues after upgrade from 3.9.x to 3.10.3. also, try to remove inputs and recreate them. Sometimes, splunk holds old connections.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: