Cisco Prime Infrastructure - syslog based config download for FWSM

[oizetbegovic]

Hi,

I'm using Cisco PI 2.0 for monitoring FWSM modules. FWSMs are discovered, modeled and configurations are successfully downloaded from them. I'd like to set up config download when a syslog message is received from FWSM. Syslog message is in fact configuration change event. It works for other Cisco devices (switches, routers,...) but I can't get it work on FWSMs.

FWSM sends this syslog message when user enters and exits config mode:

%FWSM-5-111008: User 'user' executed the 'configure terminal' command.

Can PI react to this message or PI currently doesn't have support for it?

Other Cisco devices react to this syslog message:

%SYS-5-CONFIG_I: Configured from console by user on vty0 (10.1.1.1)

[oizetbegovic]

One thing I've noticed and which I have to clarify. What is 'configuration change event'? I thought it is an event generated when user enters and exits config mode but looking at my devices I see it's not. I've got an example where PI downloaded device config after receiving interface up/down syslog messages. Can somebody please explain this behavior?