05-29-2009 05:42 AM
Hello,
I have a ISR 1801 with an ADSL interface.
Do you know where I can add dialer pool-member configuration for an ATM interface in CSM ?
I've tried lost of things including a config discovery without success.
CSM is always deleting this line. And the realtime result is always the same:
bye-bye router (needs to reboot it to restore original configuration).
Any idea ? (except stop using the bugy CSM)
Thanks,
NH
Solved! Go to Solution.
06-04-2009 07:04 AM
1. Enters interface configuration mode for the ATM interface.
2. Creates an ATM PVC for each end node (up to ten) with which the router communicates. Enters ATM virtual circuit configuration mode. When a PVC is defined, AAL5SNAP encapsulation is defined by default.
3. Specifies the ATM interface as a member of a dialer profile dialing pool. The pool number must be in the range of 1-255.
06-04-2009 07:04 AM
1. Enters interface configuration mode for the ATM interface.
2. Creates an ATM PVC for each end node (up to ten) with which the router communicates. Enters ATM virtual circuit configuration mode. When a PVC is defined, AAL5SNAP encapsulation is defined by default.
3. Specifies the ATM interface as a member of a dialer profile dialing pool. The pool number must be in the range of 1-255.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide