07-16-2008 04:09 AM
Downloaded mibs from the cisco website, copied in to CSCOpx\hum\mibmanager\mibs and changed mibs file extnesion to obj and also did the same under the CSCOpx\hum\mibmanager\mibcomplier\mibs and rename file extension to my. none of the mibs appearing under HUM.
i'm i doing anything wrong?
what i need to mibs for eigrp, hsrp and temperature.
Thanks
07-16-2008 08:44 AM
You need to actually load them using the HUM > Admin > Load MIB.
07-16-2008 08:59 AM
did that also. no success.
07-16-2008 09:04 AM
HUM is very particular about how it loads MIBs. Make sure that the MIB files are named the same name as their module, and make sure you have loaded all the required dependencies first. For example, for the CISCO-EIGRP-MIB, make sure your MIB file is named CISCO-EIGRP-MIB.my, and that you have already loaded the INET-ADDRESS-MIB.
07-16-2008 09:08 AM
extactly the issue here.
below are the mibs i got from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2&submitClicked=true&mibName=CISCO-EIGRP-MIB#dependencies. i need the CISCO-EIGRP-MIB but cannot load in to HUM without loading the dependencies first. right? so which one should i load first and last?
MIB Name Version 1 Version 2 Dependencies
1. SNMPv2-SMI
2. SNMPv2-TC
3. SNMPv2-CONF
4. SNMPv2-MIB
5. IANAifType-MIB
6. IF-MIB
7. CISCO-SMI
8. INET-ADDRESS-MIB
9. SNMP-FRAMEWORK-MIB
10. RFC1155-SMI
11. RFC-1212 Non-Cisco MIB | Non-Cisco MIB | -
12. RFC-1215 Non-Cisco MIB | Non-Cisco MIB | -
13. SNMPv2-TC-v1 Non-Cisco MIB | Non-Cisco MIB | -
14. CISCO-EIGRP-MIB
07-16-2008 09:20 AM
SNMPv2-SMI
SNMPv2-TC
SNMPv2-CONF
SNMPv2-MIB
IANAifType-MIB
INET-ADDRESS-MIB
SNMP-FRAMEWORK-MIB
IF-MIB
CISCO-SMI
CISCO-TC
CISCO-EIGRP-MIB
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide