CLI Analyzer fails to connect via SSH, after update to version 3.51

[rmorenobb]

A few weeks ago I upgraded to Analyzer 3.5.1, I think I was ok initially after the upgrade, meaning no issues, but then I started receiving the generic error: 

Connection Error

[SSH] - There was an authentication issue.

It doesn't matter what device I attempt to connect to. 

I've tried downgrading to lower versions, still get the error, tried upgrading again, same error.  

Hopefully there's a fix for this.

This is Apr 25 11:02:40.544 PDT: %SSH-4-SSH2_UNEXPECTED_MSG: Unexpected message type has arrived. Terminating the connection from 10.80.10.6

I've no issues connecting to any device prior to this.

[rmorenobb · Accepted solution]

My laptop crashed, so I had to install Cisco Analyzer on my new laptop; since then, have had no issues.  I'm not sure why it stopped working on the last laptop.