CLI Output to Local SNMP oid value

[etamminga]

Hi,

I've written a simple TCL script that executes some IOS statements to figure out a certain network state.

I'd like this state to be readable via SNMP.

Can someone tell me how to store a value in the local IOS snmp manager so it can be read by any SNMP capable agent?

Should I be looking at RFC2982 / DISMAN-EXPRESSION-MIB to store my values? Or is there any other location in the SNMP MIB I can use to store custom values?

Regards,

Erik Tamminga

[Joe Clarke]

The EXPRESSION-MIB is the way to do it reliably.  There is an example EEM Tcl policy in this forum under the Documents tab that shows how to do this.

[etamminga]

Can you please point me to the document that shows me how? A simple search on Expression-mib in this documents section doesn't give me results.

Regards,

Erik

[Joe Clarke · Accepted solution]

Here you go:

https://supportforums.cisco.com/document/77026/cli-value-2-snmp-expr-mib