cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1498
Views
0
Helpful
2
Replies

configure ip flow destinatio to a DNS record

yoav-shneor
Level 1
Level 1

Hi ,

Is it possible to configure ip flow destination to a DNS record ? 

insted of writing an ip address , to insert a name like "myflow.customer.org" . 

Is it possible ? 

do i need to config resolving ? or local host for that ? 

1 Accepted Solution

Accepted Solutions

marce1000
VIP
VIP

 

 - Put a ? at the end of the designated command, you will see what the possible options are for the host name , probably it can be a DNS name , which must then be resolvable at the time the command is being entered BUT what happens is that the translated address is burned into the running config , meaning that the 'DNS gaming' can not be used for failover purposes,

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

View solution in original post

2 Replies 2

marce1000
VIP
VIP

 

 - Put a ? at the end of the designated command, you will see what the possible options are for the host name , probably it can be a DNS name , which must then be resolvable at the time the command is being entered BUT what happens is that the translated address is burned into the running config , meaning that the 'DNS gaming' can not be used for failover purposes,

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

TNX Bro ,
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco