Configure SNMP on FTD via CLI

[NeWGuy1109]

Hello,

Apart from Platform Settings in FMC, is there anyway to configure SNMP for FTD Logical device through CLI ? I am struggling to find the CLI Commands.

Thanks

[marce1000]

 https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/213971-configure-snmp-on-firepower-ngfw-applian.html#anc9

 M.

[chanthornloeurt]

I'm using PRTG monitoring to monitor Cisco FTD 2120 for all VPN traffic and device status, but right now we've faced an issue with PRTG couldn't morning anymore due to an SNMP error, VPN tunnel, and the device is active as normal (Error message: There is no active connection for this remote IP address. code: PE123). So there is a way to restart the SNMP service on Cisco FTD or not?