Configure SNMP on FTD via CLI

NeWGuy1109 · ‎08-13-2019

Hello,

Apart from Platform Settings in FMC, is there anyway to configure SNMP for FTD Logical device through CLI ? I am struggling to find the CLI Commands.

Thanks

marce1000 · ‎08-13-2019

https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/213971-configure-snmp-on-firepower-ngfw-applian.html#anc9

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

chanthornloeurt · ‎11-25-2022

I'm using PRTG monitoring to monitor Cisco FTD 2120 for all VPN traffic and device status, but right now we've faced an issue with PRTG couldn't morning anymore due to an SNMP error, VPN tunnel, and the device is active as normal (Error message: There is no active connection for this remote IP address. code: PE123). So there is a way to restart the SNMP service on Cisco FTD or not?