Configuring Login Password Cisco Catalyst 3750

[vondoom2]

Good afternoon,

I'm upgrading from a Cisco 2960 switch to a Cisco Catalyst 3750 (ws-C3750X-24). I have just about everything from the 2960s  configuration migrated over to the 3750 except for the login password.  On the 2960 the switch boots, displays a banner, then prompts Login password, enter enable and password.  Is there was way to make it so after the banner the switch will just ask for a Login password without a username for the 3750?

[MHM Cisco World]

this can happened if you use login local 
instead use login under vty and add password 
this will make you access to SW with only password no username require 

[vondoom2]

I was able to get this to work by using the following:

Switch#: conf t

Switch# (config): line con 0

Switch# (config-line): password XXXX

Switch# (config-line): login

Switch# (config-line): end

And I had previously entered the command 'service password-encryption' to encrypt the password in the 'show run'

[MHM Cisco World]

So it OK now?

[vondoom2]

Yes, it is ok now and performing exactly like how I expected it to.  Thank you for your assistance.  You helped put me on the right path to the answer.

[MHM Cisco World]

You are so so welcome 

[Flavio Miranda]

Hi

 Not advisable but if you remove login local, it might work.

conf t

line vty 015

no login local