Hello everyone! i have a problem with the configuration of the netflow on a Cisco C1113-8F. i don't find the commands in the cli of the router, when i had configured the cisco 1921 and 897, i have used this configurations: ip flow-export source Loopback100 ip flow-export version 9 ip flow-export destination x.x.x.x xxxx interface Serial0/0/0.1 point-to-point ip flow egress interface Ethernet0/1/0.835 ip flow egress with this commands, the AVC of Cisco Prime find all interfaces in the routers and monitoring them, but with the c1113 i don't find any solutions, i have activated the evaluation of the all license, but nothing, no command. The software version is Cisco IOS Software [Fuji], ISR Software (ARMV8EB_LINUX_IOSD-UNIVERSALK9_IAS-M), Version 16.9.2 Can anyone help me?
