Configuring NTP on Cisco Prime Infrastructure 3.1.7

[Eric R. Jones]

I have configured the ntp settings on our Prime Infrastructure 3.1.7 maintenance release 7.0.0 prime pack 16 on a second gen appliance.

I can ping and traceroute to the IP address that is feeding NTP data to all our devices; however Prime is not getting synchronization from the time server. The refid is on .INIT. with a stratum of 16.

I tried a reload but nothing new.

The options for configuring NTP on Prime are extremely limited for showing data.

ej

[RichardAtkin]

Might be better if you put this in a Prime area as opposed to an ISE area.

That said, I have noticed NTP is sometimes slow to sync - wait a good while (like, hours) and check again?

[Eric R. Jones]

oops, sorry I thought I had the correct location. Ok, I'm willing to wait bit.

I was trying to find a debug command to run

ej