Hi,
just picked up eem & here is my problem...
I have very many devices that the config need ammending. Now the tacacs server address on all devices will be changed via Solarwinds NCM & when it does this I need the "^no tacacs-server host x.x.x.x$" command to trigger another change to re-configure the netflow server via eem applet. This works fine but it is a one time change so I want the applet removed with a cli command once the netflow server is changed
event manager applet notac
event cli pattern "^no tacacs-server host x.x.x.x$" sync yes default 5
action 1.0 cli command "enable"
action 2.0 cli command "conf t"
action 3.0 cli command "no ip flow-export destination x.x.x.x 9998"
action 3.2 cli command "ip flow-export destination x.x.x.x 9998"
action 3.3 cli command "no event manager applet notac"
action 4.0 cli command "exit"
action 5.0 cli command "wr"
set 6.0 _exit_status 1
The problem is once the applet is removed the write command does not load. I need to write after deleting the applet as I want no trace of it on the customer routers. Is thee any way this is possible.
Many thankx