cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
435
Views
10
Helpful
4
Replies
Highlighted
Beginner

delete fault and event syslog report - Prime LMS 4.2

Hi all

I created a fault and event report on my syslog data.  I run this report weekly.  I now need to change setting in that report but I'm not able to see where to edit this report. I see my job scheduled in the list but not able to modify anything.  Can someone help me on this

Thank you very much for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Hi ,

Report must have a Job id for that Job , you can delete it  via CLI :

1. Make note of the job ID's that you want to delete.

2. Open a dos shell and go to NMSROOT\CSCOpx\bin

3. Issue the command:

cwjava -cw NMSROOT com.cisco.nm.cmf.jrm.jobcli

3. It will take you to the Job CLI mode

4. Issue the command:

delete 1700  ( 1700 is the job ID , you wanted to delete)

5. Close all CiscoWorks browsers and issue the commands:

net stop crmdmgtd

net start crmdmgtd

6. Wait 15 minutes and log back in to CiscoWorks

 

hope it will help

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

View solution in original post

4 REPLIES 4
Highlighted
Cisco Employee

Once the reports are created and scheduled , you can't edit them .

You need to create a new one with the changes you want and delete the other.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Highlighted

Thanks.  But how can I delete it.  I cannot even edit nor delete the report.

Thanks again :)

Highlighted

Hi ,

Report must have a Job id for that Job , you can delete it  via CLI :

1. Make note of the job ID's that you want to delete.

2. Open a dos shell and go to NMSROOT\CSCOpx\bin

3. Issue the command:

cwjava -cw NMSROOT com.cisco.nm.cmf.jrm.jobcli

3. It will take you to the Job CLI mode

4. Issue the command:

delete 1700  ( 1700 is the job ID , you wanted to delete)

5. Close all CiscoWorks browsers and issue the commands:

net stop crmdmgtd

net start crmdmgtd

6. Wait 15 minutes and log back in to CiscoWorks

 

hope it will help

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

View solution in original post

Highlighted

Thanks :)

Had to know

Content for Community-Ad