Difference between 24-hour report and standard report
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-02-2009 08:23 AM
Hi,
May I know what is the difference between RME Syslog 24-hour report and standard report?
Regards
Yi Shyuan
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-02-2009 10:05 AM
The Standard Report can be run for time frames other than the past 24 hours.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-02-2009 06:09 PM
Hi Joe,
If i am not wrong 24-hour report also allows me to select different time frame if the check box of 24 hours is unchecked.
Regards
Yi Shyuan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-02-2009 06:23 PM
Yes, it does. The report has undergone quite a few changes in LMS 2.5+. At this point, the 24 hour report is there as a placeholder for those wanting a quick 24 hour look at syslog messages. It also provides a nice subject title for those looking at the report. Sure, you could create a 24 Hour Report than spans a week, but the contents would be confusing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2009 06:02 PM
Thanks for the info, Joe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-07-2010 04:48 AM
following on from this trail, how do I change the schedule and other settings for this job?
I have numerous instances of the standard and summary report scheudled but I cannot find how to edit them. I see the instances, but not the actual job.
Cheers!