Network Management

Hi, would like to check the log of my cisco switch to determine what has been changed.Tried using #show log, but what i get is only %SYS-5-CONFIG_I: Configured from console by vty01)How can I get into details what is being configured at that point of...

Hi Team,I want to capture traffic for particluar server connected to one of port on cisco switch.Ho can i do it using RMON using SNMP?Also how would i know which MIB varible to use for interface traffic tracking?Can anyone guide me n this?ThanksManis...

We have installed LMS 4.0 on windows server 2003 enterprise edition.  We are trying to create HUM Interface Utilization report of 24 port 3750 switch.  Report gives interface utilization of only 1 interface which is connected to L3 switch. How to ge...

Hello,I am new to the Cisco and networking world. I recently found out that for compliance reasons we must change the password on all of our devices since an administrator has left. With over 300 devices is there a tool I can run that would be able t...

Hi,We have many devices Cisco 3825 on our network. For some of them, the device driver is correctly discovered but not for others.- Devices correctly discovered : cisco3825 : Cisco IOS Software, 3800 Software (C3825-ADVSECURITYK9-M), Version 12.4(5a)...

I have just completed an Install of LMS 3.2I have tried to apply the latest device update package the download site for DFM.However I get the following message "consitency check for base package DFMSharedUpdates."When I look at the Common Services, S...

I am working on a bid that needs to support at least 30 operators accessing the LMS 4.0 at the same time.I could not find this information on the documentations.Thanks for any help

Netpro's can you help ?I'm running LMS 3.2 on Windows 2003 Server.When navigating to Common Services -> Device and Credentials -> Device Discovery -> Discovery Settings I'm getting a HTTP Status 500 error on the page.I have been through CSCsq63152 in...

Are there any scripts avilable to take the backup on cisco switch\Router.Show run config bakup is require

Hi PeopleI was trying to let Windows 7 get IPv6 address from CNR7 DHCPv6 server but cannot get it done.Afterwith, I read the cnr log and capture the DHCPv6 packtes to find why.I got some info about this issue, no option-20 existed in those DHCPv6 sol...

HiI am using LMS 3.2. During changes of configs trough NetConfig very often I am noticed that more than half devices are "Not Attempted" state. I have checked some and I saw that NetConfig properly implemented my changes. But the other hands some did...

Hi,Is it possible to assign some device roles on some user when using integrated authentication (non-acs).I explain, we want to allow some users (or group of users) to be able to deploy netconfig jobs only on some devices (or device groups).So we fir...