I am trying to configure below EEM script on NX-OS but it seems like NX-OS does not support E-mail notification . Below scripts works on 3850/IOS . I was wondering if anybody has any suggestion or solution to make below script work on NX-OS . Thanks
action 0.5 info type routername : Not supported on NX-OS
action 0.5 info type routername action 0.9 regex "hostname (.*)" "$_cli_result" $_info_routername action 1.0 mail server "$_email_server" to "$_email_to" from "$_email_from" subject "$_event_pub_time: Port Security Violation occured on $_info_routername" body "$_syslog_msg"
Webcast event: Catalyst 9000 Series: Best Practices and New Troubleshooting Features
This special event is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are accessible only to Cisco customers, partners, or logged...
This Document shows how we can set up 2 Factor authentication using RSA SecurID token with one time token based on a PIN to login to the Cisco DNAC Web interface.
Two factor authentication provides two or more authentication factors...
Hi Cisco Team.I have issue with Catalyst 4500 device, it is automatin reboot while use.I sent to team some information this device Version: Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK...
The network is growing and how! Data is being generated at such an exponential rate. An IDC report states that data will grow to 175 Zettabytes by 2025. With such an explosion, enterprises cannot keep sending all the incoming data directly to the cloud. T...
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/6: Power given, but Power Controller does not report Power Good we are getting this error after we upgrade our ios from 12.2(55)SE to 152-2.E9 on the 2960s ( WS-C2960S-48LPS-...