Network Management

I have been searching for a way to get the Prime compliance audit feature to look into an ASA and check if only the allowed permit rules are present and nothing more.  I was trying to find a way to get Apache VTL to check the output from "show run ac...

Hello,I am having trouble understanding the concept of Static NAT in my environment. There is a Static Bidirectional NAT as follows : Source - 192.168.1.1-10     Destination 10.10.10.1     Translated Source - Same   Translated Destination 10.80.25.12...

Hello together, is it possible to install multiple instances of the Smart Manager Satellite, not in HA mode but in parallel into 2 different subnets? They shall connect to the same virtual account in the Cisco DB.Why not HA? I want to install 2 insta...

hello ,i have a problem with copy file from disk:/defaultRepo to one repository that i make in disk:/file .I use from below command :# copy disk:/defaultRepo/VER3.3.0.303.107_BKSZ19G_CPU8_MEM3G_RAM15G_SWAP15G_APP_CK3353207043.tar.gpg ftp://reportsOnD...

Hello! i was just wondering about the appropriate way to connect my devices... What I mean is that I have a 5508-X with 5 Usable Static IPS and each Port is associated with its own IP. 2 of the IP’s, 2 different interfaces, connect to their own Route...

Hello, I want Prime Infrastructure 3.0 to manage the WLAN/Wifi guest users on a 5508 Wireless Controller. But i always got an error when adding a new user. Error(s): You must correct the following error(s) before proceeding:Error:Could not apply th...

Hi,I have a range of devices, but cannot find a single OID that will allow me to pull the serial numbers via SNMP.Can someone please help?I'd like to get for at least these models:2950296035603750PIX515eThanks,Gareth.

Hi,  I have access to cisco prime only by Gui.Somebody , know if Can i change the password of Cli from GUI?Thank you 

Hi FolksI'm looking to enable 2x2 MIMO on the cellular 4G/LTE interface which I believe this router should be able to do,  however info is a bit scarce. Its up and running at the moment, however removing the M1/DIV antenna does not slow down the conn...

Hi fellows,I am using 2 cisco 1941 routers, each have separate 500mbps internet link locally located for redundancy.GLBP protocol is running for redundancy on a configured virtual gateway perfectly. My question is that, One router state is "Active" a...

Hello All, I need some help with converting ACS config to an NPS?  

Hello!i'm looking to know, how can i do and the command that i can use, to know what the port between in same E&M card is used or unused.with a cisco command .i try with : Sh voice trace 0/0/0 .but i look for a specified command .i'm in Cisco2900 env...

Hi all,I would like to know how secrets (user passwords, tacacs keys, snmpv3 credentials ...) are protected inside Prime Infrastructure (v3.4 and after):Are these secrets encrypted and with which algorithm ?Are user passwords hashed and with which me...

I see that PI supports Meraki AP's but does it also allow you to monitor clients and users that are associated with the Meraki AP's?