Hi.
I need to somehow if possible create an applet that will run at a specific time once an event has occured.
If my router Serial goes down, I want the router to switch over to the Secondary Router (HSRP) and have the Primary router change it's HSRP Standby 1 priority from 110 to 95. This way, the Secondary will remain active even if the Primary Serial comes back up (Have a problem with them bouncing).
Using a Test Router, I substituted L2 for my Serial:
event manager applet L2_Down
event syslog pattern "LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback2, changed state to down"
action 1.0 cli command "enable"
action 2.0 cli command "config t"
action 3.1 cli command "interface fastethernet 0/1"
action 3.2 cli command "standby 1 priority 95"
action 3.5 cli command "end"
action 4.0 syslog msg " Int FE0/1 Priority Changed. Restore with Carlson OK"
This works great!
On the circuit comming up, I can restore two ways:
Trigger on L2 Up:
vent manager applet L2_Up
event syslog pattern "LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback2, changed state to up"
or use CRON:
event timer cron name Restore_Standby_1 cron-entry "00 02 * * *"
action 1.0 cli command "enable"
action 2.0 cli command "config t"
action 3.1 cli command "interface fastethernet 0/1"
action 3.2 cli command "standby 1 priority 110"
action 3.5 cli command "end"
action 4.0 syslog msg " Int FE0/1 Priority restored to normal"
What I am looking for is somehow to trigger off both events:
L2 state to UP, and do not invoke until Sunday 2 am.
Using CRON, the router will invoke the applet every Sunday at 2am. If my circuit is still down, then the router will switch over (HSRP should kick back, but the L2_Down applet won't run.. so I am in the original problem with a bouncing circuit.
