05-26-2005 11:13 PM
Dear All,
I have configured syslog server to monitor snmp information from switches/routers. But I received too many link up/down status messages everytime. I have already configured to eliminate snmp up/down link status under individual interfaces but still coming.
Please help me.
My configuration is as follows:
interface FastEthernet 0/1
no snmp trap link-status
Thanks,
Kabyar
05-27-2005 12:49 AM
Hi Kalbyar
syslogs use the syslog protocol (port 514) to recieve syslogs. so you must issue the command below to each interface
interface FastEthernet 0/1
no logging event link-status
Kind regards,
Maarten
10-04-2005 06:29 AM
Add the following line to the interfaces you don't want the link status from.
no logging event link-status
Or if you have a good ios, you can use the interface range command and do them all at once !!
Handy on a 48 port 3550 !!
10-05-2005 07:03 AM
You were configuring syslog per interface.
I think this global config will leave out linkup/linkdown SNMP traps.
snmp-server enable traps snmp authentication warmstart coldstart
I think it's better to send the linkup/down traps and use a filter on the receiving end.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide