Solved: Re: Email when a daemon stops

scott.lorenzen · ‎12-22-2010

Is there a way that I can get the system to send out an email aleart when a daemon fails to start? For example, the UTMajorAcquisition was not started this morning and we had to manual start it back up. It would have been nice to have recieved some form of an alert in regards to this service.

Joe Clarke · ‎12-22-2010

No, there's nothing built into LMS to do this. But, you could write your own script to periodically run pdshow and look for problematic daemons. Use my daemon cheat sheets at https://supportforums.cisco.com/docs/DOC-8798 as a guide for what the healthy states are.

View solution in original post

Joe Clarke · ‎12-22-2010

No, there's nothing built into LMS to do this. But, you could write your own script to periodically run pdshow and look for problematic daemons. Use my daemon cheat sheets at https://supportforums.cisco.com/docs/DOC-8798 as a guide for what the healthy states are.

scott.lorenzen · ‎12-27-2010

Thank you very much for the response and I will put this together and give it a shot.