Error Message in config Archive in RME in LMS 4.2

[akash04lingam]

                  I got the below error message in the config archive in the LMS 4.2.

CM0056 Config fetch failed for 10.0.0.10  Cause: CM0204 Could not create DeviceContext for 797 Cause: CM0202 Could not access 10.0.0.10 via SNMP. Action: Check the Read Community string Action: Check if required device packages are available. Action: Check if protocol is supported by device and required device package is installed.

Switch model type is 3560 and 2960

Please tell me the reason for this issue.

[Vinod Arya]

Are you usig only TFTP option to archive configuration. Try to use the telnet/ssh. TFTP as a protocol set for config archive.

Check the Credential verificatio job to see if the crendentials are configured correctly.

-Thanks

[akash04lingam]

Hi,

We are using TELNET , ssH and HTTPS as aprotocol set for config archive.

Credentials are configured correctly.

How to check the credential verification job?

Thanks,

Akasalingam.