Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I got the below error message in the config archive in the LMS 4.2.CM0056 Config fetch failed for 10.0.0.10 Cause: CM0204 Could not create DeviceContext for 797 Cause: CM0202 Could not access 10.0.0.10 via SNMP. Action: Check the R...
We have observed that one of the 3560 switch was rebooted with "System returned to ROM by address error at PC 0x0, address 0x0" Please explain us about this erro message. I have attached the sh...
Hi,users are getting Limited connectiity are message while connecting to wireless network. I am seeing user are able to aunthenticate but IP address are not getting from DHCP server, It is H-Reap solution setup. Please let me if you have aany idea o...
Hi,While appling tenplates from WCS, i getting status report error message AP Group VLAN "Feelgood" does not exists on controller.I have double checked the perticular AP group WLAN is created & mapped to the correct interface in the controller. This...
Hi,While connecting users to wireless connection getting Limited error connectivity message by using AP1142N with H-Reap solution. The user is able to connect without any problem with other buidling AP with same solution.Please let me know....what co...
Hi,We are using TELNET , ssH and HTTPS as aprotocol set for config archive.Credentials are configured correctly.How to check the credential verification job?Thanks,Akasalingam.
Yes,its alreday done on clinet side "netsh ras set tracing * enable' but the logs files does not show anything special, other than successful association and authentication
AP model - AIR-LAP1142N-E-K9 using Software Version 6.0.196.0 & on WISM controller as well.It is H-Reap solution setup & it is working successfully but now suddenly users are facing Limited connectivity error message while connecting some particular ...
