Error message "fabric empty" when attempting to add Fabric Interconnect in DCNM 7.2(3)

[stephenjoiner]

Hello,

I am attempting to add our Fabric Interconnects to our DCNM Data Sources but have been unable to do so. When I attempt to add them using a seed switch on the network using either SNMP v1 or v3, I get a "fabric empty" pop up error message. I haven't been able to decipher this message in the documentation or elsewhere.

Our FI's are 6248UP's running firmware 2.2(5b)A.

Thanks for your assistance! 

[Murthi]

We are facing the same issue, did your issue resolved ? , let us know how to clear the fabric empty error while adding SAN switch to Dcnm