02-14-2017 04:56 AM
Hello everybody,
I want to use a Flexible Netflow Top Talkers show command which does not appear at my Cisco ISR 4331/K9 router.
The command I want to use is:
show flow monitor <Monitorname> cache aggregate
The APPx license is activated and currently I run the newest isr4300-universalk9.16.03.02.SPA.bin Denali IOS XE. I´ve also tried the newest isr4300-universalk9.03.17.03.S.156-1.S3-std.SPA.bin IOS XE.
ISR4331#sh flow mon FlowMonitor cache ?
filter Display only matching flow records
format Specify cache display format
sort Sort the resulting flow records
| Output modifiers
<cr>
My test config looks as following:
flow record SPECTRUM_REC
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
flow exporter FlowExporter1
destination 1.2.3.4
source Loopback0
export-protocol netflow-v5
flow monitor SPECTRUM-MON
exporter FlowExporter1
record SPECTRUM_REC
Are there any dependencies for the "aggregate" keyword?
Thank you for your support!
Best regards
Jan
02-16-2017 08:58 PM
Are you using the "solid" 3.x train or the bleeding edge new 16.x train?
ps. Don't use the 16.x code if you can avoid it.
02-17-2017 12:51 AM
Hello Philip,
thank you for your reply. Currently I´m running the 16.3.2 Denali IOS XE, but I´ve tried it also with 3.16 and 3.17 IOS XE.
I testet the cache aggregate command on a Cisco C6880-X with ipservicesk9-mz.SPA.151-2.SY7 were it works like a charm.
Any idea?
Best regards
Jan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide