FXs Problem busy tone

[davidcruise]

i have fxs port in router 3845,

i configured it , whenever i dial it ,it gives me busy tone always ,and there is no call

the problem with port 1/0/1

ElGomhurya_2#sh voice port summary

IN OUT

PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC

========= == ============ ===== ==== ======== ======== ==

1/0/0 -- fxs-ls up dorm on-hook idle y

1/0/1 -- fxs-ls up up on-hook idle y

1/1/0 -- fxs-ls up dorm on-hook idle y

1/1/1 -- fxs-ls up dorm on-hook idle y

voice-port 1/0/0

timeouts interdigit 2

!

voice-port 1/0/1

timeouts interdigit 2

!

voice-port 1/1/0

timeouts interdigit 2

!

voice-port 1/1/1

timeouts interdigit 2

!

!

!

dial-peer cor custom

!

!

!

dial-peer voice 2222 pots

destination-pattern 2222

port 1/0/0

!

dial-peer voice 1 voip

destination-pattern .T

session target ipv4:172.21.100.1

!

dial-peer voice 8833 pots

destination-pattern 8833

port 1/1/0

!

dial-peer voice 6677 pots

destination-pattern 6677

port 1/1/1

!

dial-peer voice 1234 pots

destination-pattern 1234

port 1/0/1

[spremkumar]

Hi

Can you post out the config related to the dial peer POTS and VOIP ? also whether you have enabled the voice ports which is instaled in the router..

regds

[davidcruise]

2222

8833

6677 working normally

but 1234 gives me busy tone whenever i dial it

[darren.staples]

I am having the same problem

have a vg224 with multiple faxes.

When call from fax to fax completes the port

is fine (dormant/onhook)

but when a call is incomplete, like if you call from your phone, (hear the fax attempt negotiation), then hangup.

that port's state remains up (up/onhook) and until reset the port, it is not usable.

have tried adding "timeouts call-disconect 10"

and "timesout wait-release 10", reset the port, but made no difference. then changed the 10 to 5 - no help. removed call-disconnect and left just wait-release - no help.

any ideas?