How I do CLI template in Cisco Prime to enable SSH connection to devices?

[cstcom]

I need to enable ssh connection to devices, to do a CLI Template, i have a doubt if i can send "yes" and leght when generate rsa key.

How be the template to next commands?

conf t
Enter configuration commands, one per line.  End with CNTL/Z.
ROUTER(config)#ip domain-name domain.name
ROUTER(config)#crypto key generate rsa
% You already have RSA keys defined named ROUTER.domain.name.
% Do you really want to replace them? [yes/no]: yes
Choose the size of the key modulus in the range of 360 to 2048 for your
  General Purpose Keys. Choosing a key modulus greater than 512 may take
  a few minutes.

How many bits in the modulus [512]: 1024
% Generating 1024 bit RSA keys, keys will be non-exportable...[OK]

ROUTER(config)#ip ssh version 2
ROUTER(config)#ip ssh time-out 120
ROUTER(config)#ip ssh authentication-retries 3
ROUTER(config)#line vty 0 4
ROUTER(config-line)#transport input telnet ssh
ROUTER(config-line)#end
ROUTER#write
Building configuration...
[OK]
ROUTER#

[Marvin Rhoads]

You can do this using the interactive command feature. The User Guide even cites the specific example you are asking about when describing how this works:

Adding Interactive Commands

An interactive command contains the input that must be entered following the execution of a command.

To enter an interactive command in the CLI Content area, use the following syntax:

CLI Command<IQ>interactive question 1<R>command response 1 <IQ>interactive question 2<R>command response 2

where <IQ> and <R> tag are case-sensitive and must be entered as uppercase.

For example:

#INTERACTIVE

crypto key generate rsa general-keys <IQ>yes/no<R> no

#ENDS_INTERACTIVE

Source:

http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/user/guide/pi_ug/config-temp.html#47279