cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
906
Views
0
Helpful
1
Replies

How to Clear "last seen" from "link status" in DCNM GUI

iandacosta
Level 1
Level 1

Recently during a trouble shooting session to identify if we had a problem with a cable or port via MDS 9710 switch. The device alias, port WWN, FcId, switch interface, vender, etc. all picked up the B side of the setup after swapping cables. We have since resolved the issue being a downed port on B side. The cables for B side have been placed back where they belong. Now in my DCNM-SAN GUI for the device I get 2 listings. 1 for the current A side setup and 1 for the cable swap with the B side. The  B side settings all have "last seen" and time stamp from when cables were swapped. I would like to know how to clear this result from GUI. Thanks

1 Reply 1

iandacosta
Level 1
Level 1

Found answer by selecting device and purging it. Issue is resolved..

Review Cisco Networking for a $25 gift card