cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
600
Views
0
Helpful
0
Replies
Highlighted
Beginner

How to use Cisco Prime's Shared Policy Objects, specifically "Interface Role" and "IPv4 Network Object", in Config Templates

I am fairly new to Cisco Prime's Config Templates.  I was reading about the "Interface Role" under "Shared Policy Objects" and it looks like something I would definitely like to incorporate into my templates, but I cannot find any examples anywhere of how you utilize one after you create it.  There are some sample Interface Roles defined, e.g. "Tunnel Interface 100" shows as being applied to sample template "AVC-Internet."  The template "AVC-Internet" is an IWAN/AVC template, and when I pull it up I see the option "Apply to Interface Role" as an available dropdown under "Template Detail, and "Tunnel Interface 100" is selected there.  I do not, however, see how to make use of an Interface Role in a CLI template, which is what I am building.  Is this possible?  If so, can someone direct me to a link that shows how to set it up?

 

Thanks,

-Mat

 

0 REPLIES 0
Content for Community-Ad