cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
615
Views
0
Helpful
1
Replies

I have a problem to monitoring voltage in LMS 3.2

I have assigned to implement Cisco work LMS3.2 for monitoring network devices such as C6509, C4507.

I try to used MIB from CISCO-ENVMON-MIB.my to generate Devices Voltage Report by create template poller.

voltage001.jpg

then create a poller

voltage002.jpg

after that I saw a pop up error

I check in RME Device that how many SNMP time out configured, all is 15 second.

I try incresing SNMP time out to 60 second and create Voltage Poller again but can't solve the problem.

Do I wrong?

Do I have other choice to generate Voltage Monitoring Report, Pls.

Note: All devices have been enable snmp trap energywise and reachable

Thank you.

1 Reply 1

Sorry I forgot an error picture.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers